• Icon: Sub-task Sub-task
    • Resolution: Fixed
    • Icon: L3 - Default L3 - Default
    • 2.0.0
    • None
    • documentation
    • None

      AT:

      • in the report section of the user guide, I can read about:
        • target value comparison and what it is for
        • which reports I can perform a target value comparison on
        • how to use the double button | target value | gear | and what each part is for
        • the target value modal:
          • how to set target values pick from diagram
          • how to set target values in the input field with unit
        • what the target value heatmap shows
        • how to interact with the target value heatmap (tooltips, badges)

        This is the controller panel for Smart Panels app

            [OPT-1162] Document the target value comparison

            Kyrylo Zakurdaiev added a comment - - edited

            Review hint:

            • there is a typo after the report configuration table: `flownodes`
            • I would restructure the guide a bit, so that the target value description

              If you saved the target values, the normal duration heatmap is replaced with a target value visualization. In this new visualization, flow nodes with an average duration larger than the specified target value are highlighted in red. If you mouse over one of the nodes the tooltip shows the target duration value, the actual duration and the relative percentage the actual value is of the target value. You can also see the target value as a badge on the diagram.

              is placed next to the screenshot which shows the whole thing.

            Kyrylo Zakurdaiev added a comment - - edited Review hint: there is a typo after the report configuration table: `flownodes` I would restructure the guide a bit, so that the target value description If you saved the target values, the normal duration heatmap is replaced with a target value visualization. In this new visualization, flow nodes with an average duration larger than the specified target value are highlighted in red. If you mouse over one of the nodes the tooltip shows the target duration value, the actual duration and the relative percentage the actual value is of the target value. You can also see the target value as a badge on the diagram. is placed next to the screenshot which shows the whole thing.

              Unassigned Unassigned
              johannes.heinemann Johannes
              Votes:
              0 Vote for this issue
              Watchers:
              1 Start watching this issue

                Created:
                Updated:
                Resolved: